Product Name:  
Electrical EGT Gauge  
Product Description:  
Product Number:  
EGT Electrical Gauge 400 to 2200 DEG F  
TS-0701-2011  
-
-----------------------------------------------------------------------------------------------------------------------  
IMPORTANT NOTES:  
Please thoroughly read and understand these instructions before commencing this installation.  
Ensure that the car and exhaust system are cold before commencement of installation.  
RECOMMENDATIONS  
Turbosmart recommends that your gauge is fitted and adjusted by an appropriately qualified technician  
Gauge mount cup (TS-0101-2024) Sold separately  
------------------------------------------------------------------------------------------------------------------------  
HOW TO INSTALL YOUR EXHAUST GAS TEMPERATURE GAUGE  
Exhaust Gas Temperature Sensor  
The exhaust gas temperature (EGT) gauge requires a reliable temperature signal from the exhaust system to provide an  
appropriate EGT indication.  
After deciding the location of the sensor, drill an 8.70 mm diameter hole. Use a 1/8 NPT tap to thread the hole for the included  
NPT fitting.  
First secure the 1/8 NPT fitting by hand, and then turn 1.5 revolutions by a socket/spanner. Torque to 3 Nm (2.2 ft.lbf)  
After the 1/8 NPT fitting is securely fastened, insert the bush, nut and thermocouple in series as shown in figure below.  
The thermocouple depth is to be set at approximately half the diameter of the exhaust pipe.  
Secure the sensor assembly by tightening the securing nut. Torque to 6Nm (4.4 ft.lbf)  
Be sure not to over tighten the EGT sensor as it may cause sensor failure or thread damage.  
Route the sensor cable to the gauge. Ensure cable is kept away from heat as much as possible.  
1
www.TURBOSMARTONLINE.com  
Wiring  
Both of the exhaust gas temperature gauge and sensor must be connected to the vehicle’s ground (chassis or earth).  
Soldering or crimp on electrical connectors must be used on all electrical connections.  
Unused wires must be insulated with electrical tape in order to prevent unwanted electrical connections.  
Follow safe electrical operating practice.  
Refer to the table and diagrams below for further details  
Component  
Gauge  
Gauge  
Gauge  
Gauge  
Gauge  
EGT Sensor  
EGT Sensor  
Wire  
Yellow  
Red  
Black  
Pink  
Blue  
Pink  
Blue  
Connect to  
Fused +12VDC battery supply  
Ignition switched +12VDC supply  
Ground (Vehicle chassis or earth)  
EGT sensor positive voltage supply  
EGT sensor negative voltage supply  
Positive voltage supply (connect to gauge pink wire)  
negative voltage supply (connect to gauge blue wire)  
Operation & Troubleshooting  
Once the electrical connections and EGT sensor installation are completed, turn the car key to “on” position. The EGT gauge  
will illuminate and the needle will be positioned at a temperature reading.  
Start the car and check for any exhaust leaks.  
The needle position will change relative to the exhaust gas temperature. If the needle does not move relative to the exhaust  
gas temperature, ensure that all electrical connections are correct and that the EGT sensor is installed correctly as per  
instructions above.  
Monitor the gauge reading against the operating conditions of the engine. The temperature should be at a minimum during  
cold start then slowly increase and remain at a normal operating temperature.  
If the display does not illuminate, ensure that the gauge electrical connections are correct.  
If the display illumination/operation is not switched with ignition, ensure that the red wire is connected to an ignition switched  
source not a constant +12VDC source.  
If the display needle is erratic, ensure that all electrical connections to the EGT sensor are correct.  
2
www.TURBOSMARTONLINE.com  
TURBOSMART  
ONE YEAR LIMITED WARRANTY  
Turbosmart is a company built on Customer Satisfaction and Service. That is why all of our products go through regimented test procedures before they are packaged and shipped. Turbosmart stands  
behind its products for one full year after purchase. Terms of Warranty, Service and Returns are as follows:  
Limited Warranty: Turbosmart warrants its products to be free from defects in material and workmanship under normal use and if properly installed for a period of one year from date of purchase. If found  
to be defective, it will be replaced or repaired if returned prepaid along with proof of date of purchase. This shall constitute the sole remedy of the purchaser and the sole liability of Turbosmart to the extent  
permitted by law, the foregoing is exclusive and in lieu of all other warranties or representations whether expressed or implied, including any implied warranty of merchantability or fitness. In no event shall  
Turbosmart be liable for special or consequential damages. This warranty is only valid on products purchased from Turbosmart Authorized Dealers.  
Service: After the warranty period has expired, repair service is charged based on a minimum and maximum charge rate. (Contact Customer Service for current rate).  
Returns: When returning a Turbosmart product for repair, it must be accompanied by a completed Customer Warranty Form and RMA number. To access this form please go to our website  
www.turbosmartonline.com and you will find it on the Downloads page.  
THE TURBOSMART PLEDGE  
DO NOT USE ANY TURBOSMART PRODUCT UNTIL YOU HAVE CAREFULLY READ AND UNDERSTOOD THE FOLLOWING AGREEMENT.  
Please call if you have any questions or do not understand this agreement. Refer to our brochure, website or catalogue for terms and conditions and further information regarding your product. Turbosmart  
appreciates your business and pride ourselves on our customer service. We are always happy to offer you advice and will provide you with help in any way we can. The purpose of this agreement is to  
avoid any problems or hard feelings.  
We sometimes make mistakes, as do our dealers, distributors and suppliers. Even customers can sometimes order the wrong parts. Do not use, modify, install, trial assemble, nick, drop, scratch or adjust  
any part until you first check for any damage. Damage must be reported immediately. NO EXCEPTIONS. If there are any components missing please contact your authorized reseller immediately upon  
receipt of your shipment. Missing components must be reported within five (5) business days of receipt. Parts returned for any reason MUST BE IN RESALABLE CONDITION. It is YOUR responsibility,  
“THE CUSTOMER” to carefully package any returns to avoid shipping damage. Insurance is highly recommended. Credit cannot be issued for damaged goods.  
Turbosmart warranties the quality of the products it designs and manufactures to be free of defects in material and workmanship. This limited warranty is extended only to the original purchaser and may not  
be transferred or assigned. This limited warranty applies to any product, which after careful inspection by Turbosmart, after receipt of the product from our authorized reseller, is found to have a defect in  
either material or workmanship. Any modifications to the product will void any and all warranties and will not be exchanged. Before installation, check new car warranty. Turbosmart is not responsible for  
voiding any original manufactures warranty.  
All warranty claims must be returned to the nearest Turbosmart Office, you must return the product and sales receipt, at your own expense, accompanied by the Customer Warranty Form stating the reason  
for the claim. Proof of purchase must be provided with any warranty claim and will be verified with the authorized reseller from which the product was purchased.  
If all the above procedures are followed, and the product is found to be defective in either workmanship or material, Turbosmart shall either repair or replace the product, at its sole discretion, and sole cost.  
This limited warranty does not cover or apply to any personal injury, labor charges or any other incidental costs or damages caused by the defective product. The individual purchaser acknowledges and  
agrees that the disclaimer of any liability for personal injury is a material term for this agreement and the individual purchaser agrees to indemnify Turbosmart and to hold Turbosmart harmless for any claim  
related to the item of the equipment purchased. Under no circumstances will Turbosmart be liable for any damages or expenses by reason of use or sale of any such equipment.  
THIS LIMITED WARRANTY IS THE ONLY EXPRESS WARRANTY, WHICH APPLIES TO TURBOSMART PRODUCT AS EXPRESSLY GIVEN IN LIEU OF ANY OTHER WARRANTY EXPRESSED OR  
IMPLIED, INCLUDING THAT OF MERCHANTABILITY. ANY IMPLIED WARRANTY INCLUDING THAT OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICCULAR PURPOSE IS HEREBY  
LIMITED BY THE SAME TERMS AND TIME LIMITATIONS SET FORTH IN THIS LIMITED EXPRESS WARRANTY AND OTHERWISE EXCLUDED. EXCEPT FOR THOSE OBLIGATIONS ASSUMED  
HEREIN, TURBOSMART ASSUMES NO OTHER OBLIGATIONS IN CONNECTION WITH THE SALE OF ITS PRODUCTS.  
IN THE EVENT THAT THE INDIVIUDAL PURCHASER DOES NOT AGREE WITH THIS AGREEMENT THE BUYER MAY PROMPTLY RETURN THIS PRODUCT, IN  
A NEW AND UN-USED  
CONDITION, WITH A DATED PROOF OF PURCHASE, TO THE PLACE OF PURCHASE WITHIN SEVEN (7) DAYS FROM THE DATE OF PURCHASE FOR A FULL REFUND. THE INSTALLATION OF  
THIS PRODUCT INDICATES THAT THE INDIVIDUAL PURCHASER HAS READ AND UNDERSTOOD THIS AGREEMENT AND ACCEPTS ITS TERMS AND CONDITIONS.  
Happy motoring!  
The Turbosmart Team.  
3
www.TURBOSMARTONLINE.com